x Want to participate? Join the group to interact
  • State Verified Answer
  • Replies 1 reply
  • Subscribers 27 subscribers
  • Views 1781 views
  • Users 0 members are here
Browse Forums
Announcements
19
topics
3
replies
General Discussion
790
topics
1k
replies
gaberdistributors

Crystal Reports Help

SOLVED
Posted By

Does anyone know how to change the size of paper in crystal reports?  I have changed it where I thought I should in the report, but when I print the address label it still shows up on a full sized letter paper on my screen.  When I print the address label to my screen I would like the white that represents the paper to just only be the size of the label, not a whole sheet of paper.

Thank you!

  • 0
    verified answer

    The address label relies on the details section of the report.  If you right-click on any blank area of the address label, select Report, Section Expert.  Click on the Details section and on the right side you will notice a layout tab.  The Layout tab allows you to change your Detail Size and Gap Between Details.  Based on those four variables the Number of Details will change at the bottom.  Keep in mind that if you right-click on any blank area and select Designer, Printer Setup, you are able to select your printer, paper and orientation.  They can influence your layout tab settings too.  Once you make changes to your address label, make sure you select the same printer and paper size when using the modified form.

    Hope this points you in the right direction.

*Community Hub is the new name for Sage City