Error 107 during Sage 2021 migration

Posted By sued2 over 2 years ago

We have a client that is currently on Sage 2016. They have Scanco and Mapadoc. We have installed Sage 2021 on a new server with Product Update 2 and Scanco. At the end of the Migration we receive an Error 107. Once you click OK it closes out. We are able to access the software but have not attempted data conversion because we're uncomfortable with the migration not finalizing. Sage suggested we rebuild the system files in the Live environment, then try again. We are willing to do that, but were curious if anyone else has run into this.

Thanks

Sue

Top Replies

sued2 over 2 years ago +1

Was able to work with a Great tech at Sage and he ran Process monitoring on the system while it was migrating. It failed on the sy_griddefinition.m4t file. Made a copy of the file and ran UFAR on the file…

Parents

0 Kevin M over 2 years ago

(You didn't install MAPADOC on the target system too? Typically the source module / enhancement list has to match the destination.)

KB 98722 and 56083 might be worth a look.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Kevin M over 2 years ago

(You didn't install MAPADOC on the target system too? Typically the source module / enhancement list has to match the destination.)

KB 98722 and 56083 might be worth a look.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 sued2 over 2 years ago in reply to Kevin M

We did NOT install MAPADOC yet. They instructed us to not install it until after the data was migrated. Sage had mentioned KB 98722. We are going to try the rebuild of all the system files and then try to migrate again. I'll let you know the outcome.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Sage 100

Error 107 during Sage 2021 migration

Top Replies

COMMUNITY

COMPANY

PARTNERS

SUPPORT & TRAINING