What was the original version of the check used for modifications for your clients?  If you can post the version used I can post a list of the changes between that base version and PR 2.20.

Thanks 

John  Nichols 

Sage  

2.19.4

There are no differences between PR_Check1.rpt, PR_Check2.rpt, PR_DirectDepositStub.rpt in PR2.19.4 and PR2.20.

John Nichols

Sage

Good to know.  When I installed PR 2.20, a discrepancy was found between the installed (modified) forms and the new ones, which were installed.  Then, a forms conversion was required.  If there were no changes, then why were the templates replaced?  And, by the way, a forms conversion is required even if the forms aren't replaced.

PR2.20 is a new version of the PRChecks and DD stub. The keywords in the RPT have been updated to "Converted to version P/R 2.20". When a report/form is run a comparison of the KEYWORDS in the .RPT is run. If the KEYWORDS don't match the system level "2.20" the conversion will kick off, verify DB, update the keywords and save the .rpt. This check is performed everytime RPT's are run.

Running the clients reports created on a previous level will run the conversion.

Pre conversion - "Converted to version P/R 2.19".

Post conversion - "Converted to version P/R 2.20"

There are no differences between PR_Check1.rpt, PR_Check2.rpt, PR_DirectDepositStub.rpt in PR2.19.4 and PR2.20.  (except the KEYWORDS)

Installation will lay down updated copies of the RPT's in the MAS90\Reports directory.  Customized RPT's are stored under the individual company directory or/mas_system. 

Hope this clarifies. Thx John