"No reference endpoint set" when starting the Batch server

Question

Hi, 
 Recently it was installed X3 in a customer but when starting the Batch server appears this error "No reference endpoint set". on the other hand, no problems when we access and working to endpoints. We dont see the reason, all seems ok

Markus Huber · Answer

Hi, 
 when you install a V12 and configure as last step the solution in Syracuse (Administration - Endpoints - X3 solution) it takes several minutes after klicking the Save button. During this time in the right lower corner the blue hourglass keeps turning. If you don't wait till this is complete finished and click out of the window or close it you can have afterwards problems like yours. The x3 solution is not configured completely. I would deconfigure the solution in Syracuse and create it new. 
 
 Hope that helps.

Mikael · Answer

Hi, 
 
 Check the Administrative -- > Endpoints --> Batchserver and validate that you have entered your x3 folder as administrative endpoint for the batchserver.

Sage X3

"No reference endpoint set" when starting the Batch server

Top Replies

COMMUNITY

COMPANY

PARTNERS

SUPPORT & TRAINING