Hi Bennie, 

Thank you for this article. I have followed the steps and applied it to a sales order report. I have used the variables (calcs) as instructed, but my result is as follows:  for Value :=VARIABLE4.VALUE + VARIABLE2.VALUE the result is for example 150150 instead of 300 (150 + 150)

Please advise how I can fix my calc to add the variables as a running total and then also what my calc should look like for the column total. 

Thank you!!

eg: Total Cubes = Item Cube x Qty. This is correct as 532400

The calc after this one is incorrect

Hi Bennie, 

Thank you for this article. I have followed the steps and applied it to a sales order report. I have used the variables (calcs) as instructed, but my result is as follows:  for Value :=VARIABLE4.VALUE + VARIABLE2.VALUE the result is for example 150150 instead of 300 (150 + 150)

Please advise how I can fix my calc to add the variables as a running total and then also what my calc should look like for the column total. 

Thank you!!

eg: Total Cubes = Item Cube x Qty. This is correct as 532400

The calc after this one is incorrect

Hi Roelien 

Are you e-mail address for the same Roelien I mailed on 29 September 2021?  (for obvious privacy reasons I can't publish your e-mail address here) 

If yes, I'll send you an meeting invite so I can have a closer look at how you configured the calculated values on the report.

Blessings!

Bennie 

Hi Bennie, yes. I have sent you an email. Thank you so much

Thanks Roelien

I've sent you a meeting invite