I set up a data model based on a view in Sage. Then I created a worksheet view and everything works well including the ability to filter based on columns within the data model. I noticed that when I went to set up a distribution job, I didn't have the ability to filter like I did in the worksheet view. The only place where you can filter was on the Web Views section but these filters are global parameters.I tried using the conditions tab but from the onlinehelp, it says "Conditions apply at the Data Model level and not at the View level. The condition does not filter the view but rather, it checks if the condition exists."

Is there any other way to apply filters to the Distribution Job? I'd rather not create multiple worksheet views with the filters already applied.

This is the filter section from the worksheet view

This is the filter section under Web Views in Distribution.

Thank You

Andrew